Either way will work, but the fabric strip makes it easier. We will remove the cable shield and wrap the drain wire around the cable jacket and tack it down with one of the copper fabric strips for this demonstration. Fold the cable shield backward, and then you will use the cable shield as the bonding point. The first way is to NOT remove the cable shield but snip off the ESD drain wire. There are essentially two ways of bonding the cable shield to this internal ground plug. Don't accidentally cut off the ESD drain wire in this process, as you will need it. Make a tiny nip in the cable shield and remove it. If you see any, you may have nicked a conductor. Check for slices in the cable shield near the cable jacket edge. They are much tougher than plain copper strips and do not add to your cable's overall thickness! ![]() The copper fabric strips are copper-infused fabric with a permanent conductive adhesive. Recommended additional accessory to make termination of the cable shield a lot easier:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |